Amazing Adding A New Circuit To A Breaker Box

Opening the main circuit breaker panel box and adding a circuit is actually pretty easy.

Adding a new circuit to a breaker box. American electrical advice forum. The other two are used to secure the breakers in place by slipping into a notch on the breaker. If you follow our safety steps in order and to the letter you ll be fine.

Always turn off the electric when working on an electrical outlet. Safety instructions for adding a new circuit turn the power off before you start anything turn off the power. Tighten the clamp to secure the wires.

Hold the cover securely as you remove the fourth. Snap the breaker into place by clipping it to the hot bus bar. Check for correct operation of the new circuit light outlet etc with a test light or meter.

Next notice four bars that run vertically. You only have to connect three wires to add a circuit and each circuit wire is color coded. Turn on the main breaker and test your new circuit breaker.

Two of these will be flat and carry the electricity to the house breakers. But before you turn off the power turn off all the appliances. Check out more home improvement tips on our weekly.

These are called the bus bars. Running a new electric circuit is a pretty simple task that can be accomplished with a little bit of effort care and the right tools. Connect any new circuits to the subpanel attaching the hot wire to a circuit breaker and the other wires to their respective buses.