Supreme Non Shunted Tombstone Diagram

If your led tube light is a single ended type then it cannot be installed on shunted tombstones.

Non shunted tombstone diagram. First of all using the wrong type can vo. You must also know that most t8 led tubes need non shunted tombstones sockets. Why is it important to know what kind of sockets or tombstones are in your linear fluorescent or led light fixture.

Because there are exceptions to this visual difference the safest way to figure out what kind of sockets you have is to use a voltage meter. Don t worry with our vi. To retrofit a single ended power sep led tube the.

Remove or disconnect all of the wiring connected to the starter ballast. Non shunted sockets have contacts that are not joined or connected. Most voltage meters will either light up or ring or beep if the electrical.

Their contacts are not connected or joined. To shunt or not to shunt. This type of socket is used with sunco led t8 tubes and also in dimming ballasts programmed or rapid start ballasts.

Another way to determine the compatibility of the led light to shunted and non shunted tombstones would be to check whether the led light is single ended or double ended. Electrical current flows through multiple tracks or paths in a non shunted tombstone. Sunco uses non shunted tombstones for our direct wire led t8 tubes.

In order to understand fluorescent ballasts you need to know about lampholders 2 lamp parallel ballast wiring diagram using non shunted lampholders. Turn of the circuit or disconnect power going to the fixture. Insert the non shunted tombstones and make sure they snap securely into place.