Fun Release Wire From Light Switch

The new switch you have probaly has 2 copper screws.

Release wire from light switch. Learn which light switches c. If you don t have a ground wire leave the green screw unconnected. Hold the switch in the other hand and pull gently at the same time you will rotate the switch left and right.

Loosen the terminal screws until the bare wire ends move freely. Rotate the receptacle to place its face against the wall near the box if the screwdriver release slots are on the rear. If you have a ground wire connect the ground wire to the green screw.

How to properly add wire up a north american grounded electrical outlet receptacle from a wall light switch single pole 3 way. How to video on how to release the solid copper wire from the back push in connectors on an electrical wall outlet subscribe https goo gl ey8fmyinstagram. Make note of how the bare wire end curves around the post of the screw as it will have bent into a curve when the terminal screw was tightened down at the time of installation.

Gently pull the entire light switch assembly outward away from the wall so that the wire terminals on both sides of the switch are exposed and able to be easily worked with using a screwdriver. Connect the black wire to the other brass screw. If the switch that was there is a standard light switch with two brass screws on it and one green screw you can connect the red wire to either of the brass screws.

Place the blade of the proper size screwdriver in the screwdriver release slot and push down on the screwdriver while pulling on the wire with the pliers. Grasp the wire you want to remove about an inch or two from the switch and hold firmly. Make note of where te black wires go and where the white wires go.