Looking Good Adding A Circuit To A Breaker Box

Connect any new circuits to the subpanel attaching the hot wire to a circuit breaker and the other wires to their respective buses.

Adding a circuit to a breaker box. Opening the main circuit breaker panel box and adding a circuit is actually pretty easy. Snap the breaker into place by clipping it to the hot bus bar. But if at any point you re unsure how to proceed or feel uncomfortable with the project call an electrician.

Next notice four bars that run vertically. Touch 1 probe to ground the bar that has bare or green and white wires connected or neutral the bar that has just white or just bare or green wires connected and touch the other probe to the screw terminal of a circuit breaker that has a black red or blue insulated wire connected. If you follow our safety steps in order and to the letter you ll be fine.

But there are some safety precautions and if you ignore them you could kill yourself. Adding a 12 guage wire and 20 amp breaker to the breaker panal amazon link to great products that every diyer and handyman should know about switch and recep. There is a great tip on stripping the wire to the right length.

You only have to connect three wires to add a circuit and each circuit wire is color coded. Insert the two main lines from the electrical supply pole into the two terminals at the top of the breaker box. Tighten the lugs with either a slotted screwdriver or an allen wrench.

Installing connector running line stripping wire. Adding a new line to your breaker box.