Heartwarming Wiring A Pull Cord Switch

There should be sufficient wiring to allow you to do this and as with the lighter duty switch spray with the maintenance spray and attempt to make the switch work properly.

Wiring a pull cord switch. Thread the collar of the. Undo the two retaining screws carefully pull down the switch a little. Mount the pull switch onto the junction box and secure the mounting screws with a slotted screwdriver.

Screw a light bulb into the new fixture. Because it s the last point of the circuit i decided to wire all at the switch that s why i. Tighten the screw with a slotted screwdriver.

The wires leading to the pull switch are always live with the pull cord acting as the switch. The retaining nut holds the switch into the light fixture. The two blue wires were fixed together in one terminal the two brown ones in separate terminals.

Discard the old switch. With 6 amp pull cord switch for lights there are 2 3 wires. In this video i m installing and wiring a pull cord switch.

Install the new pull cord switch. In older homes they might be the same colour or in newer homes you will find black or brown or even blue. Remove the wire connector from the black wire on the switch that connects it to the black wire from the light fixture.

Twist a wire connector onto to one black wire from the switch and onto the black wire from the light fixture connecting them together. It has l1 l2 although this seems to have no terminal to screw onto wire c and earth. If this has not worked the whole unit must be replaced.